03-05-2008 09:27 AM - edited 03-05-2019 09:34 PM
Does anyone know how to disable flow-control on a 2851 Gigabit Ethernet interface? I do not want pause frames being sent to the switch which has flow-control turned off.
Thanks,
Mike
03-05-2008 06:40 PM
I might be mistaken, but I thought pause frames were only sent if the other side confirmed it understood them.
03-06-2008 06:32 AM
On switchport, the following line appears:
input flow-control is off, output flow-control is unsupported
03-06-2008 07:35 AM
Appears then that flow control was not negotiated to be active?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
