6509 Switch& FWSM&firewall vlan-group

Unanswered Question
Mar 6th, 2008

Hi all,

We create new VLANs & will assign these VLANs to the Firewall Services Module

By using the below command:-

(Config)# Firewall vlan-group firewall_group vlan_range

My question is there any need to restart the FWSM after adding new vlan into vlan group??

Regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jon Marshall Thu, 03/06/2008 - 05:18

Hi

No you don't have to reboot anything. Just make sure if you are running a pair in separate chassis that you update both firewall vlan-group entries on both 6500's because if they become out of sync then failover will not work.

HTH

Jon

Actions

This Discussion