Hi,

I've 2 Catalyst 4503, each one of the with a WS-X4224-RJ45V blade and it says this error:

18:03:43: %C4K_IOSMODPORTMAN-4-INLINEPOWEROVERWARNING: Inline power exceeds threshold: Module status changed to 'Pwr Over'

Checking the config, the power default is on 15400 mW, but if I check the inline consumption, it show me this:

sh power inline module 3

Available:800(w) Used:43(w) Remaining:757(w)

Interface Admin Oper Power(Watts) Device Class

From PS To Device

--------- ------ ---------- ---------- ---------- ------------------- -----

Fa3/1 auto off 0.0 0.0 n/a n/a

Fa3/2 auto off 0.0 0.0 n/a n/a

Fa3/3 auto off 0.0 0.0 n/a n/a

Fa3/4 auto on 429496 42946. IP Phone 7911 2

Fa3/5 auto off 0.0 0.0 n/a n/a

Fa3/6 auto off 0.0 0.0 n/a n/a

Fa3/7 auto off 0.0 0.0 n/a n/a

Fa3/8 auto off 0.0 0.0 n/a n/a

Fa3/9 auto off 0.0 0.0 n/a n/a

Fa3/10 auto off 0.0 0.0 n/a n/a

Fa3/11 auto power-deny 0.0 0.0 n/a n/a

Fa3/12 auto off 0.0 0.0 n/a n/a

Fa3/13 auto off 0.0 0.0 n/a n/a

Fa3/14 auto power-deny 0.0 0.0 Cisco/Ieee PD 2

Fa3/15 auto off 0.0 0.0 n/a n/a

Fa3/16 auto off 0.0 0.0 n/a n/a

Fa3/17 auto off 0.0 0.0 n/a n/a

Fa3/18 auto on 429496 42944. IP Phone 7941 2

Fa3/19 auto on 429496 42946. IP Phone 7911 2

Fa3/20 auto off 0.0 0.0 n/a n/a

Fa3/21 auto on 429496 42944. IP Phone 7941 2

Fa3/22 auto on 429496 42946. IP Phone 7911 2

Fa3/23 auto on 429496 42944. IP Phone 7941 2

Fa3/24 auto off 0.0 0.0 ATA 186 n/a

--------- ------ ---------- ---------- ---------- ------------------- -----

Totals: 6 on 429493 257672

The values mentioned are out of the threshold stablished, so it seems the IOS is providing wrong information. There is a bug related (CSCef49715), but it's not the same blade and power supply.

TIA

Andres Pasten

Adexus S.A.