03-06-2008 06:09 PM - edited 03-05-2019 09:36 PM
Hi There;
Can anyone tell me - if I have two serial interfaces on a 2811, do I need to specify that one will be used for RS422 and the other for RS232. If so, what command do I use to do this?
thanks
Solved! Go to Solution.
03-08-2008 10:58 AM
Darren
There is generally not any command to identify the type of interface connector. The type of card will determine what kind of connector is supported and when the interface card supports multiple connector type there is logic within the interface to check which pins are activated in the connector and determine the type of connector automatically.
HTH
Rick
03-08-2008 10:58 AM
Darren
There is generally not any command to identify the type of interface connector. The type of card will determine what kind of connector is supported and when the interface card supports multiple connector type there is logic within the interface to check which pins are activated in the connector and determine the type of connector automatically.
HTH
Rick
03-10-2008 02:09 PM
Thanks Rick
03-10-2008 02:51 PM
Darren
I am glad that my answers were helpful. Thank you for using the rating system to indicate that your question was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can know that they will read responses which successfully resolved the question.
The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: