03-07-2008 08:47 AM
When we try to pull a Chassis Slot Detail report out of RME in Ciscoworks for any 6000 series with a SUP1A, it always shows "0".
Other SUP models report the correct information. Compatability issue?
Thank you.
03-07-2008 09:09 AM
What version of code is this switch running?
03-07-2008 09:12 AM
It is various versions of the CatOS 7.6(x) across multiple switches with Sup1A engines.
We have one switch with a Sup2 within the same CatOS 7.6 and it reports fine.
Thank you,
03-07-2008 10:22 AM
This is most likely due to the entPhysicalVendorType for the chassis slots being zeroDotZero instead of cevContainerSlot. In this case, the slot is ignored by RME inventory, and the total slot count is not properly reflected.
Typically, I would expect this problem to be tied to the software, so I wouldn't expect a Sup2 to work, but you might want to compare the entPhysicalVendorType values from the two switches.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: