V12.4 no service-module command or serial interfacd

Unanswered Question
Mar 7th, 2008

I have new 2851 with 12.4. I installed a vwic 2mft-t/e1 card but can't configure. I don't have the service-module command of a serial interface, what am i mssing?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Richard Burts Fri, 03/07/2008 - 14:16


Some of the documentation that I have looked at describes beginning by configuring controller e1 slot/port. Have you done the controller configuration? That may be required to see the serial interfaces (especially on a card that can do both voice application as well as data application)?



b-ulrich Fri, 03/07/2008 - 14:22


Your probably going to need the command:

'card type t1 0 0' The 0 0 depends on what slot you have the card installed in I believe.

The the controller config will then show up.


This Discussion