Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
429
Views
0
Helpful
2
Replies

2960G uplink

lenpet_hun
Level 1
Level 1

‎03-08-2008 08:16 AM - edited ‎03-05-2019 09:37 PM

hi guys,

i've got four 2960G-48TC-L switches. i have to uplink all four to a catalyst 4500 with a single GLC-SX-MM, and i figured i would connect the switches to each other with GLC-T modules, and uplink the one that is on top of the stack. so the question is: is it lame to connect three of the switches to only one, or should they be connected to each other as well?

Labels:
0 Helpful
2 Replies 2

lenpet_hun
Level 1
Level 1

‎03-08-2008 08:26 AM

well i just realized, that the four uplink port on the 2960G-48TC-L are dual purpose ports, so i'll just use rj45, i don't need the GLC-T at all (but correct me if i'm wrong)

0 Helpful

glynnd
Level 1
Level 1
In response to lenpet_hun

‎03-12-2008 10:46 PM

yes, you can just use the copper ports rather than the fiber ports if distance between the 2960 and the 4500 is not a problem

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card