03-10-2008 08:34 AM - edited 03-15-2019 09:20 AM
Hi all,
I'm encountering problems with a FXO / FXS configuration.
I have the following config:
CIPC --> CCME-1 --> FXO --> connected to FXS port -> CCME-2 --> CIPC
Outgoing calls from CCME-1 to CCME-2 phones are working.
Incoming calls from CCME-2 to CCME-1 phones are not working.
The call is established for 1 to 2 seconds and then disconnects.
I have configured an outgoing dialpeer on the CCME-2 router, pointing to the FXS port. Have an incoming dial-peer on CCME-1. I have also a connection plar opx on the voice port in CCME-1 pointing to the CIPC.
The voice port configuration on both sides is the default config, I did not add any commands.
I don't have any experience with analog ports.
Has someone an idea where the problem could be?
thanks
Solved! Go to Solution.
03-11-2008 03:15 AM
Hi,
Are you going through a pbx? cme-1 is getting reverse battery after connect, configure "no battery-reveral" under voice-port", or try swapping cable pins.
03-10-2008 09:07 AM
Hi, if you do debug ccapi you will see why the call is being closed. Don't you have ip connectivity between the CMEs ? That would let you call over VoIP avoiding use of the voice port.
Hope this helps, please rate post if it does!
03-10-2008 09:12 AM
03-10-2008 09:15 AM
Likely CME-1 is closing the call.
03-10-2008 09:28 AM
I have a similar debug from the other side on CCME-1.
Would you suggest to configure anything on the FXO port?
If I establish a call from CCME-1 to CCME-2 the debug shows me, even with a regular call disconnect, a call disconnect cause value = 16
03-10-2008 10:05 AM
Can you talk few seconds and then it drops ?
Can you collect "debug vpm signal" on cme1.
03-11-2008 01:53 AM
no I cannot talk for few seconds.
E.g. if I activate AutoAttendant on CCME-1 and call the number I can hear from time to time the "welc..." then the call drops. Most of the tests I do ends without hearing anything. If I forward to Voicemail I did not hear anything, the call disconnects after 1-2 seconds (based on the CIPC infos). If I forward via connection plar opx to the CIPC I see the call ringing, and as soon as I answer the call, the call disconnects after 1-2 seconds based on the CIPC infos.
I attached the debug vpm signal infos.
thanks
03-11-2008 03:15 AM
Hi,
Are you going through a pbx? cme-1 is getting reverse battery after connect, configure "no battery-reveral" under voice-port", or try swapping cable pins.
03-11-2008 05:16 AM
Hi,
Thank you, using the no battery-reversal command the calls are now working!
And yes, the CCME-1 is working as PBX.
03-11-2008 05:33 AM
Glad to know it's working now. My question was if fxo/fxs are directly connected or what is in between.
Thanks for the nice rating and good luck!
Paolo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: