cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
440
Views
0
Helpful
2
Replies

DLSW ER+

axfalk
Level 1
Level 1

Can someone please explain if DLSW ER+ transport mechanism encapsulates the SNA packets into IP or using Layer 2 communication?

thnx...

2 Replies 2

lamav
Level 8
Level 8

Ax man:

What the heck is DLSW ER+?? Never heard of it...

As far as DLSW+ is concerned, the short answer to your question is both.

The long answer is as follows...

SSP is used. Switch-to-Switch Protocol (SSP) is a protocol used between DLSw nodes (routers) to establish connections, locate resources, forward data, and handle flow control and error recovery. This is truly the essence of DLSw.

In general, SSP does not provide for full routing between nodes because this is generally handled by common routing protocols such as RIP, OSPF, or IGRP/EIGRP. Instead, SSP switches packets at the SNA data link layer.

It also encapsulates packets in TCP/IP for transport over IP-based networks and uses TCP as a means of reliable transport between DLSw nodes.

HTH

If so, please rate my post.

Victor

Thanks for your response..DLSw+ ER is ethernet redundancy, that works a bit different from the usual bridged DLSw..

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco