ASA 5510 Remove VPN configuration

Unanswered Question

Hi


I am having some problems with the configuration af Remote VPN.


I have just received a new ASA 5510 and I have made the basic configurations so that I can browse the internet. I then went through the VPN Wizard and I can connect to the VPN without any problems but I can't connect to the internet through the VPN tunnel. I want all the traffic to pass through the VPN tunnel so no split tunnel.


Our configuration is:

Outside interface: Static public IP

Inside interface: 192.168.1.0

I am using the latest ASDM and ASA software.


As far as I am informed it should be possible to connect to the Outside interface through VPN and go back out to the internet through the same interface, but how do I configure it?


I have searched and searched and I can't find a solution to the problem.


Is there any special settings I need to be aware of?


/Lasse

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
vkapoor5 Mon, 03/17/2008 - 08:38
User Badges:
  • Bronze, 100 points or more

This document describes how to set up a PIX Firewall 7.0.1 and later to perform IPsec on a stick. This setup applies to a specific case where the PIX does not allow split tunneling, and users connect directly to the PIX before they are permitted to go to the Internet.


http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805734ae.shtml

Actions

This Discussion