03-11-2008 04:31 AM - edited 07-03-2021 03:31 PM
I am trying to connect a WLC 4402 5.0.148.0 mode with an HP 2800 switch. The switch is configured thunk mode with LACP protocol.
The WLC in LAG mode uses the protocol LACP? How can configure them switch HP?
Thanks.
Mirko Severi.
03-11-2008 08:50 AM
not supported, Mirko. Refer to this for further detail:
http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40mint.html#wp1186245
11-02-2011 09:12 AM
Hi Mirko,
NO Not possible. Can they not do just MODE ON .i.e no negotiation
If not, you have to create individual ap-managers to avoid running into any issues.
Thanks..Salil
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: