Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
223
Views
0
Helpful
1
Replies

3560 traffic ratelimiting (IN&OUT)

viju.m.dev
Level 1
Level 1

‎03-11-2008 05:38 AM - edited ‎03-05-2019 09:40 PM

Hello,

Can anybody help me to configure rate limitting on my 3560 interfaces? I tried to apply a policy-map to an interface and the switch accepts service-policy input but not accpeting service-policy output. Even the switch accepts input policy, it is not working. I heared that engress policing doest support on 3560 platforms due to ASIC limitations. Is there any way to do this.

Your advise much appriciated..

Labels:
0 Helpful
1 Reply 1

Joseph W. Doherty
Hall of Fame
Hall of Fame

‎03-11-2008 06:29 AM

The configuration guide's QoS section should provide the information you seek. E.g. http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_44_se/configuration/guide/swqos.html

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card