NM-CUE installation access problem

Unanswered Question
Mar 11th, 2008
User Badges:

I'm trying to configure NM-CUE Cisco Unity Express 3.0.1


I have already set the commands

interface Service-Engine1/0

ip unnumbered GigabitEthernet0/1

service-module ip address 192.168.1.2 255.255.255.0

service-module ip default-gateway 192.168.1.1


If I try to access by the command :


CME#service-module service-Engine 1/0 session


Trying 192.168.1.1, 2066 ... Open

User Access Verification

Username:


A user and pass is asked but I have no configured nither the user nor the pass, is a new module


Is there a default pass in order to access to the module?


I tried to reset the pass via command but this message is displayed:


CME#

Mar 11 18:44:37.521: %SERVICEMODULE-3-PASSWORDRESET: Service module Service-Engine1/0 password reset not supported


C3845-ADVENTERPRISEK9-M), Version 12.4(15)T3


CHow can I have access to the module?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion