AIR-ANT2506 problem

Unanswered Question
Mar 11th, 2008
User Badges:

i have AIR-ANT2506 installed on ap's for outside and it seems as though i am loosing signal strentgh on them when i investigate the ant is filling up with water due to the lip that is on them. is there a model better suited for my needs.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bcolvin Tue, 03/11/2008 - 16:08
User Badges:
  • Bronze, 100 points or more


a quick question were the antennas mounted with the cable at the bottom ( the antenna mounted vertically) or out the top (antenna mounted Inverted)


bcolvin Tue, 03/11/2008 - 22:12
User Badges:
  • Bronze, 100 points or more

that is probably why they collected water, antennas are designed to be installed with the cable exiting the bottom. there is no drain hole when they are mounted inverted.

when used indoors you would mount them inverted but outdoors right side up.


tpacjer Wed, 03/12/2008 - 06:07
User Badges:

is there a similar model antenna that is water sealed or do i need to have sealant put around the cable.

bcolvin Wed, 03/26/2008 - 20:29
User Badges:
  • Bronze, 100 points or more

as far as i know all outdoor antennas have a weep hole to allow condensation to drain.



This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode