03-11-2008 04:14 PM - edited 03-03-2019 09:05 PM
It must router 3845 and I buy a card VWIC2-1MFT-T1/E1, when configure the controller (Pri-Group timeslot 1-31) leaves a message "Not enough DSP resources available", is required to have DSP so that it works like a contingency ISDN for data. The IOS is ip-voice 12.4T, thanks
03-11-2008 05:33 PM
Hi, load a non-voice image like ipbase and you will be able to configure PRI as for data only.
Hope this helps, please rate post if it does!
03-17-2008 01:04 PM
It is necessary to have installed DSP.
03-17-2008 01:09 PM
As mentioned above, when you load an image without voice support, you will be able to do data isdn pri without dsp. Else, you will need to have dsp.
Hope this helps, please rate post if it does!
03-17-2008 01:18 PM
It is possible to be config without DSP to receive calls ISDN and to raise data by contingency from a remote ISDN-BRI.
The command ISDN TEST CALL INTERF s 0/2/0:15
and debug. the message received is:
ISDN Se0/2/0:15 **ERROR**: call_setup_ack_proceeding: NO HDLC available b channel 14 call id 0x8009
03-17-2008 02:26 PM
I have PVDM.
03-17-2008 03:30 PM
Which exact IOS are you running?
This is how you configure for integrated data and voice on isdn PRI:
http://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/intserv.html
Note I recommend you use 12.4(11)XJ4 for that.
As a recognition to those providing answers, please rate useful posts with the scrollbox below!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide