cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
808
Views
0
Helpful
6
Replies

E1 ISDN-PRI

l.torres
Level 1
Level 1

It must router 3845 and I buy a card VWIC2-1MFT-T1/E1, when configure the controller (Pri-Group timeslot 1-31) leaves a message "Not enough DSP resources available", is required to have DSP so that it works like a contingency ISDN for data. The IOS is ip-voice 12.4T, thanks

6 Replies 6

paolo bevilacqua
Hall of Fame
Hall of Fame

Hi, load a non-voice image like ipbase and you will be able to configure PRI as for data only.

Hope this helps, please rate post if it does!

It is necessary to have installed DSP.

As mentioned above, when you load an image without voice support, you will be able to do data isdn pri without dsp. Else, you will need to have dsp.

Hope this helps, please rate post if it does!

It is possible to be config without DSP to receive calls ISDN and to raise data by contingency from a remote ISDN-BRI.

The command ISDN TEST CALL INTERF s 0/2/0:15

and debug. the message received is:

ISDN Se0/2/0:15 **ERROR**: call_setup_ack_proceeding: NO HDLC available b channel 14 call id 0x8009

I have PVDM.

Which exact IOS are you running?

This is how you configure for integrated data and voice on isdn PRI:

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/intserv.html

Note I recommend you use 12.4(11)XJ4 for that.

As a recognition to those providing answers, please rate useful posts with the scrollbox below!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: