user & pass required for new NM-CUE ????

Unanswered Question
Mar 11th, 2008

I'm trying to configure NM-CUE Cisco Unity Express 3.0.1 on a 3845

I have already set the commands

interface Service-Engine1/0

ip unnumbered GigabitEthernet0/1

service-module ip address

service-module ip default-gateway

If I try to access by the command :

CME#service-module service-Engine 1/0 session

Trying, 2066 ... Open

User Access Verification


A user and pass is asked but I have no configured nither the user nor the pass, is a new module

Is there a default pass in order to access to the module?

I tried to reset the pass via command but this message is displayed:


Mar 11 18:44:37.521: %SERVICEMODULE-3-PASSWORDRESET: Service module Service-Engine1/0 password reset not supported

C3845-ADVENTERPRISEK9-M), Version 12.4(15)T3

How can I have access to the module?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Brandon Buffin Wed, 03/12/2008 - 06:03

Check the authentication settings on the terminal line associated with the CUE module. In your case you should have "line 66" in your config. Sounds like there is a username/password required for this line.

Hope this helps. If so, please rate the post.



This Discussion