03-12-2008 04:12 AM - edited 03-05-2019 09:41 PM
Is there a command to set an interface back to default values? Rather than go through a series of no commands?
thanks
Solved! Go to Solution.
03-12-2008 04:15 AM
Hi,
Router(config)# default interface Serial0
should do the trick.
Hope this helps! Please use the rating system.
Regards, Martin
03-12-2008 04:15 AM
Hi,
Router(config)# default interface Serial0
should do the trick.
Hope this helps! Please use the rating system.
Regards, Martin
03-12-2008 04:19 AM
Thanks,
knew it would be simple - just couldn't find it
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide