Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
570
Views
0
Helpful
2
Replies

Basic Question - Setting an interface to default values

Go to solution
gcossins
Level 1
Level 1

‎03-12-2008 04:12 AM - edited ‎03-05-2019 09:41 PM

Is there a command to set an interface back to default values? Rather than go through a series of no commands?

thanks

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
mheusing
Cisco Employee
Cisco Employee

‎03-12-2008 04:15 AM

Hi,

Router(config)# default interface Serial0

should do the trick.

Hope this helps! Please use the rating system.

Regards, Martin

View solution in original post

0 Helpful
2 Replies 2

Go to solution
mheusing
Cisco Employee
Cisco Employee

‎03-12-2008 04:15 AM

Hi,

Router(config)# default interface Serial0

should do the trick.

Hope this helps! Please use the rating system.

Regards, Martin

0 Helpful

Go to solution
gcossins
Level 1
Level 1
In response to mheusing

‎03-12-2008 04:19 AM

Thanks,

knew it would be simple - just couldn't find it

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card