What to do about CME Flash Wear?

Unanswered Question
Mar 12th, 2008
User Badges:

Our CME installation is "new" so I'm sure it probably won't be an issue for us anytime soon, but I see from the Unity GUI that our "Flash Wear" is .04%. This begs the question of what to do when it reaches a higher percentage? I know you can "format flash:" from the router, but is that needed when Flash Wear exceeds...what...20%? What threshold(s) should I be concerned with and what are my options for when my Flash Wear gets too high? I tried searching for help on this topic at Cisco.com and the only hits I was able to receive were regarding SNMP Trap variables.

Please advise. Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Wed, 03/12/2008 - 08:19
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, the "problem" is limited to aim-cue.

The flash in there is replaceable for if and when it becomes unusable.

NM-cue has an hard-disk, so no issue.

Hope this helps, please rate post if it does!


This Discussion