Our CME installation is "new" so I'm sure it probably won't be an issue for us anytime soon, but I see from the Unity GUI that our "Flash Wear" is .04%. This begs the question of what to do when it reaches a higher percentage? I know you can "format flash:" from the router, but is that needed when Flash Wear exceeds...what...20%? What threshold(s) should I be concerned with and what are my options for when my Flash Wear gets too high? I tried searching for help on this topic at Cisco.com and the only hits I was able to receive were regarding SNMP Trap variables.
The flash in there is replaceable for if and when it becomes unusable.
NM-cue has an hard-disk, so no issue.
Hope this helps, please rate post if it does!
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
