cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
412
Views
0
Helpful
1
Replies

Route Plan Report

Hi, i'm using CM4.2

When I make a Route Plan Report of one extension (example 7032).. It appears 2 times 7032 in the same partition... one is SEP and other is ADP !

SEP0002B341ECAF

ADP0002B341ECAF

What is that ADP for ? Can I remove it ? Why does it appear ?

Thanks.

Andrei.

1 Accepted Solution

Accepted Solutions

Michael Owuor
Cisco Employee
Cisco Employee

hello Andrei,

ADP = Autogenerated Device profile

The autogenerated device profile, which is a special device profile, gets generated when you configure a phone for Cisco CallManager Extension Mobility and choose "Use Current Device Settings" from the Phone Configuration window. The autogenerated device profile then associates with a specific phone to be the logout device profile.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_2_1/ccmcfg/b06dvprf.html#wp1028937

Regards,

Michael.

View solution in original post

1 Reply 1

Michael Owuor
Cisco Employee
Cisco Employee

hello Andrei,

ADP = Autogenerated Device profile

The autogenerated device profile, which is a special device profile, gets generated when you configure a phone for Cisco CallManager Extension Mobility and choose "Use Current Device Settings" from the Phone Configuration window. The autogenerated device profile then associates with a specific phone to be the logout device profile.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_2_1/ccmcfg/b06dvprf.html#wp1028937

Regards,

Michael.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: