VG224 conference

Unanswered Question
Mar 13th, 2008

Hi,

I configured VG224(mgcp), but i am not able to do conference with analog phones. if i press flash button, call is transfering this is the problem i am facing can you please give me the solution on this matter

Regards

stn

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rob.huffman Thu, 03/13/2008 - 05:35

Hi Stn,

You would need to use SCCP for these features to work;

Check out Table 1 from this VG224 doc (show SCCP support for Conference);

http://www.cisco.com/en/US/products/hw/gatecont/ps2250/products_data_sheet09186a00801d87f6.html

Conference Call

Initiates a three-party conference.

During an active call, user presses hookflash for dial tone, dials a third party, and then presses hookflash again to connect all three parties

From this doc;

http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080483a76.html#wp1178205

Hope this helps!

Rob

PS: How did you make out with the DST Emergency? I did respond to one of your posts but I never heard back to see if your issue was resolved :)

Actions

This Discussion