03-13-2008 09:02 AM - edited 03-05-2019 09:44 PM
Hi all,
I've read that CEF per-destination load sharing is enabled by default on the 6500 switches. What global commands enables this ? Is there an 'interface' command needed as well?
Here's the details of the switch
IOS (tm) s72033_rp Software (s72033_rp-PK9SV-M), Version 12.2(17d)SXB5, RELEASE SOFTWARE (fc1)
1 24 CEF720 24 port 1000mb SFP WS-X6724-SFP
2 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
3 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
4 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
5 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
6 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
7 2 Supervisor Engine 720 (Active) WS-SUP720-3B
8 2 Supervisor Engine 720 (Hot) WS-SUP720-3B
9 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
Thanks,
Mike
03-13-2008 09:38 AM
Mike:
In global config mode:
ip cef
ip cef distributed (if there are DFC daughter cards on the line cards)
HTH
Victor
03-13-2008 10:59 AM
Thanks Victor,
Is there anything needed within an interface configuration?
-Mike
03-13-2008 11:13 AM
NO. Any interface that supports CEF will autonatically begin CEF switching once you configure it globally.
HTH
If so, kindly rate my posts.
Thanks
victor
03-13-2008 11:28 AM
Thanks again for the info, Victor.
-Mike
03-13-2008 11:30 AM
You got it, buddy. Post here anytime.
Victor
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide