03-13-2008 09:02 AM - edited 03-05-2019 09:44 PM
Hi all,
I've read that CEF per-destination load sharing is enabled by default on the 6500 switches. What global commands enables this ? Is there an 'interface' command needed as well?
Here's the details of the switch
IOS (tm) s72033_rp Software (s72033_rp-PK9SV-M), Version 12.2(17d)SXB5, RELEASE SOFTWARE (fc1)
1 24 CEF720 24 port 1000mb SFP WS-X6724-SFP
2 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
3 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
4 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
5 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
6 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
7 2 Supervisor Engine 720 (Active) WS-SUP720-3B
8 2 Supervisor Engine 720 (Hot) WS-SUP720-3B
9 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX
Thanks,
Mike
03-13-2008 09:38 AM
Mike:
In global config mode:
ip cef
ip cef distributed (if there are DFC daughter cards on the line cards)
HTH
Victor
03-13-2008 10:59 AM
Thanks Victor,
Is there anything needed within an interface configuration?
-Mike
03-13-2008 11:13 AM
NO. Any interface that supports CEF will autonatically begin CEF switching once you configure it globally.
HTH
If so, kindly rate my posts.
Thanks
victor
03-13-2008 11:28 AM
Thanks again for the info, Victor.
-Mike
03-13-2008 11:30 AM
You got it, buddy. Post here anytime.
Victor
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: