Port Security on cat6500

Unanswered Question
Mar 14th, 2008

i configure port security mac-address sticky on a cat6500, but i cann hit the global command " clear port-security sticky interface nr access"

Thanks for any response

Alain

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jagdeep Gambhir Fri, 03/14/2008 - 06:04

Alain,

The clear port-security sticky is available only on the "smaller" platforms (2940, 2950, 2955, 2960, 2970, 3550, 3560, 3750, but not on the higer end platforms, such as the Cat4500 and Cat6500.

The reason not to include this command was "clear" command is to be used for dynamic addresses only. Any configured addresses should be cleared via the [no] form of the corresponding commands."

Regards,

~JG

Do rate helpful posts

Actions

This Discussion