ASA enable mode with ACS

Unanswered Question
Mar 14th, 2008


When I SSH to my ASA is there anyway to go straight to enable mode? We use RSA SecurID which means I have to wait for the token to change before I go into enable mode at the moment.

ASA config:

aaa authentication ssh console CISCO-ACS LOCAL

aaa authentication serial console CISCO-ACS LOCAL

aaa authentication http console CISCO-ACS LOCAL

aaa authorization command CISCO-ACS LOCAL

aaa accounting enable console CISCO-ACS

aaa accounting serial console CISCO-ACS

aaa accounting ssh console CISCO-ACS

aaa accounting command CISCO-ACS

ACS config (Group Level)

Privilege level 15

Read/write command authorisation set


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Jagdeep Gambhir Fri, 03/14/2008 - 10:46

Unfortunately that is not possible as ASA does not support Exec Authorization.



Do rate helpful posts


This Discussion