Hi
When I SSH to my ASA is there anyway to go straight to enable mode? We use RSA SecurID which means I have to wait for the token to change before I go into enable mode at the moment.
ASA config:
aaa authentication ssh console CISCO-ACS LOCAL
aaa authentication serial console CISCO-ACS LOCAL
aaa authentication http console CISCO-ACS LOCAL
aaa authorization command CISCO-ACS LOCAL
aaa accounting enable console CISCO-ACS
aaa accounting serial console CISCO-ACS
aaa accounting ssh console CISCO-ACS
aaa accounting command CISCO-ACS
ACS config (Group Level)
Privilege level 15
Read/write command authorisation set
Thanks