Hi

When I SSH to my ASA is there anyway to go straight to enable mode? We use RSA SecurID which means I have to wait for the token to change before I go into enable mode at the moment.

ASA config:

aaa authentication ssh console CISCO-ACS LOCAL

aaa authentication serial console CISCO-ACS LOCAL

aaa authentication http console CISCO-ACS LOCAL

aaa authorization command CISCO-ACS LOCAL

aaa accounting enable console CISCO-ACS

aaa accounting serial console CISCO-ACS

aaa accounting ssh console CISCO-ACS

aaa accounting command CISCO-ACS

ACS config (Group Level)

Privilege level 15

Read/write command authorisation set

Thanks