I'm trying to get a route-map to work for a NAC installation that I am doing for a customer. From the feature navigator and command reference I keep reading that this platform/software combination supports policy routing. I know that in the other L3-switching platforms (3560/3750) you have to do a "sdm prefer" to allocate resources to the route-map, however there is no mention (that I can find) about an equivalent command for the Catalyst 4507R.
1) The IP next hop IS layer-3 adjacent to the Catalyst 4507R
2) There IS an ARP/MAC entry for the next-hop address
3) The "set ip default next-hop" works and matches, but the "set ip next-hop" does not. (Go figure :P)
Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(25)EWA13, RELEASE SOFTWARE (fc1)
ip access-list extended NACACL
remark *** Redirect Traffic ***
permit ip 10.75.6.0 0.0.0.255 any
route-map NACRedirect permit 10
match ip address NACACL
set ip next-hop 10.0.3.15
! Attached to an upstream L3 switch communicating via EIGRP
ip address 10.10.10.2 255.255.255.0
ip policy route-map NACRedirect
This is what occurs when I change it to "ip default next-hop"
route-map NACRedirect, permit, sequence 10
ip address (access-lists): NACACL
ip default next-hop 10.0.3.15
Policy routing matches: 36 packets, 2603 bytes <====
But I need "next-hop" NOT "default next-hop" to work.
No match in the bug-tracker regarding the behavior.
Any assistance is greatly appreciated!