Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1933
Views
0
Helpful
1
Replies

NAT and Layer 3 switches

jkauffman
Level 1
Level 1

‎03-14-2008 03:40 PM - edited ‎03-05-2019 09:46 PM

What low-end 48 port 100/1000 switch supports NAT, if any? We have a pair of old 5500's with RSM's with NAT statements on the RSMs. As we upgrade and collpase our backbone; I still have the NAT requirement and was hopping to do all layer 3 "stuff" in the switch. Any ideas?

Labels:
0 Helpful
1 Reply 1

Jon Marshall
Hall of Fame
Hall of Fame

‎03-14-2008 03:53 PM

I'm afraid the bad news is that you need the 6500 switch to support NAT. I know, it's annoying but it is often easier/cheaper to just get a router for this.

Jon

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card