Issue - Two WLAN Controllers

Answered Question
Mar 15th, 2008
User Badges:

I have two controllers. I am trying to force via the AP configuration (primary, secondary, tertiary) an AP to go to a specific controller. All AP's are static. Good code rev on controllers (4.1.185.0) and I have done this many times. The AP just goes into a constant rebooting mode and attaches only to the primary controller. The only way I can reset it, is by getting to it quickly and resetting the AP to the primary controller. The event log never shows it attempting to contact controller 2 at all? Anyone seen this?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Rob Huffman Sat, 03/15/2008 - 09:18
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode