03-15-2008 07:06 AM - edited 07-03-2021 03:33 PM
I have two controllers. I am trying to force via the AP configuration (primary, secondary, tertiary) an AP to go to a specific controller. All AP's are static. Good code rev on controllers (4.1.185.0) and I have done this many times. The AP just goes into a constant rebooting mode and attaches only to the primary controller. The only way I can reset it, is by getting to it quickly and resetting the AP to the primary controller. The event log never shows it attempting to contact controller 2 at all? Anyone seen this?
Solved! Go to Solution.
03-15-2008 09:18 AM
Hi Sean,
There are some good ideas in this thread;
Hope this helps!
Rob
03-15-2008 09:18 AM
Hi Sean,
There are some good ideas in this thread;
Hope this helps!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: