Interface Tracking in HSRP

Unanswered Question
Mar 15th, 2008
User Badges:

I have confiugred the MHSRP successfully. I am able to provide the redundency and load balancing. But problem is that I am not able to track the Interface connected with WAN.


It is ethernet interface and I mentioned it in HSRP configration, but when it goes down, it is not detected by HSRP.


Below mention is the configuration of HSRP


interface GigabitEthernet0/1

ip address 13.1.1.6 255.255.255.0

ip nat inside

ip virtual-reassembly

duplex auto

speed auto

standby 1 ip 13.1.1.4

standby 1 priority 150

standby 1 preempt

standby 1 track GigabitEthernet0/0

standby 2 ip 13.1.1.8

standby 2 preempt

standby 2 track GigabitEthernet0/0


Kindly help me out, how to solove this problem. Anyway to configure tracking any other method, if yes then how to configure that method. Why not it is working with HSRP.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Edison Ortiz Sat, 03/15/2008 - 08:57
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Configure SLA with ICMP Echo to the next-hop by following this document:

http://www.cisco.com/en/US/docs/ios/12_4/ip_sla/configuration/guide/hsicmp.html


Once the SLA is configured, verify the track goes down when the link fails.


Attach the track to the MHSRP configuration along with a decrement value. Currently, I don't see any decrement on the standby 1 track GigabitEthernet0/0 command.


Here is a good example of using track along with HSRP

http://www.cisco.com/en/US/docs/ios/12_4/ip_appl/configuration/guide/haipbtrk.html#wp1184322



HTH,


__


Edison.

Actions

This Discussion