cisco 4948 configuration problem problem (Kindly provide CLI configuration

Unanswered Question
Mar 16th, 2008

Having two cisco 4948 switch ,Want to uplink with two Links one with Ethernet port 10.XX n/W and other Fiber Uplink with 97.XX N/w also requirement is such that 1 to 16 port work with 10.XX N/w and 17 to 42 with 97.XX n/w and 43,44 port use for trunking with other switch with same configuration.Also require to Define VRRP for above both links with one VIP.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Edison Ortiz Sun, 03/16/2008 - 09:31

#config t

(config)#vlan 10,97

(config)#exit

#config t

(config)# interface rang 1-16

(config)# switchport host

(config)# switchport access vlan 10

(config)# interface ran 17-42

(config)# switchport host

(config)# switchport access vlan 97

(config)# interface rang 43-44

(config)# switchport trunk encap dot1q

(config)# switchport mode trunk

_________

Switch 1 VRRP

(config)# interface vlan 10

(config)# ip add 10.x.x.10

(config)# vrrp 10 ip 10.x.x.1

(config)# vrrp 10 priority 105

(config)# vrrp 10 preempt

(config)# interface vlan 97

(config)# ip add 97.x.x.10

(config)# vrrp 97 ip 97.x.x.1

(config)# vrrp 97 priority 105

(config)# vrrp 97 preempt

Switch 2 VRRP

(config)# interface vlan 10

(config)# ip add 10.x.x.20

(config)# vrrp 10 ip 10.x.x.1

(config)# interface vlan 97

(config)# ip add 97.x.x.20

(config)# vrrp 97 ip 97.x.x.1

HTH,

__

Edison.

Actions

This Discussion