2811 E1 Card

Unanswered Question
Mar 16th, 2008

I have cisco 2811 with VWIC-2T1/E1-RAN installed. I have IOS

(C2800NM-IPVOICE-M), Version 12.4(18)

But it is not recognizing the E1 card.even card router is not recognizing the card type command.

WIC Slot 0:

Unknown WAN daughter card

WIC module not supported/disabled in this slot

Hardware Revision : 3.0

Top Assy. Part Number : 800-25833-03

Board Revision : E0

Deviation Number : 0-0

Fab Version : 02

PCB Serial Number : FOC11302ZTB

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Version Identifier : V01

Product (FRU) Number : VWIC-2T1/E1-RAN

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 04 BF 41 03 00 C0 46 03 20 00 64 E9 03

Please tell me which IOS will support these commands.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Mark Yeates Sun, 03/16/2008 - 19:24

You should be using the ITP release for your 2821. The use of the VWIC-2T1/E1-RAN requires Cisco IOS Software Release 12.4(11)SW1 or later. The latest version is 124-11.SW3.bin.

Mark

Actions

This Discussion