Total noob here. I'm tying to connect my 2600 to host via crossover but can't seem to ping the router.
ip address 192.168.2.1 255.255.255.0
ip address 192.168.2.10 255.255.255.0
I'm racking my brains here any help would be greatly appreciated. Any suggestions?
Is there a green light on each side of the connection?
I've had issues where a host will auto-cross-over the cable and a cross-over cable just confuses the host's NIC.
try these and post the output:
sh int f0/1
last question : any acls applied?
The common initial questions, have you tested the cable, and what is the output of the show interface f0/1 ?