03-17-2008 08:13 AM - edited 02-21-2020 01:56 AM
Hi
I have Site to Site VPN set up, I can ping and access files across the VPN tunnel.
However the issue is that, it doesn't display the computers on the workgroup on my network neighbourhood( ie remote computers can not see the main office computers)
Is there a way I will be able to see these computers? if so what command can I use to allow me see these computers.
Thanks
Solved! Go to Solution.
03-17-2008 10:38 AM
hi
You will have to enable wins on both sides of the tunnel. If you have wins servers on both sites, then set them as replication partners. If you only have a wins server in the main office, then set remote clients to use that for wins.
regards
John
03-17-2008 10:38 AM
hi
You will have to enable wins on both sides of the tunnel. If you have wins servers on both sites, then set them as replication partners. If you only have a wins server in the main office, then set remote clients to use that for wins.
regards
John
03-17-2008 12:11 PM
Hello John
Does it mean that, it got nothing to do with the vpn setup on these two cisco routers (VPN gateways )?
The customer does not have any wins server. they only use file sharing.
The VPN tunnel is up and the two networks can ping each other and remote sites can access files at the main office.
What I would like to know is whether this customer's request has got nothing to do with the VPN configuration.
I will be very grateful if somebody can reply to me as quickly as possible.
Kind regards
Tarek
03-18-2008 07:49 AM
Hello John,
Your solution works. Thank you very much.
Tarek
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: