ASA5505 getting started - cannot save config

Unanswered Question
Mar 17th, 2008
User Badges:

After config factory-default I get LAN access to 192.168.1.1 via ASDM and make changes, but when I save and power cycle all my interfaces all go to administrative shutdown. Same thing if I save via console using write memory. Is there an additional step other than "save configuration to flash" in ASDM. Can I see the saved result (Show flash indicates no changed files) and is there a trick to activating a previously saved configuration. Thanks in advance for helping out a newbie

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
PeterBodzay Sun, 03/23/2008 - 00:54
User Badges:

Hi,

I'm rather new aswell to the ASA but maybe this will help in some way:


After a "write memory" command "show startup-config" should display the same as "show running-config". As I can understand it does not in Your case.


If You do a "show bootvar" do You have a "CONFIG_FILE" set?

If so maybe you should take a look at this:

http://www.cisco.com/en/US/docs/security/asa/asa80/command/reference/b.html#wp1352110

Look for "boot config"


My "CONFIG_FILE" is not set, and as I can understand it should not be in a default config.


Hope this helps in som way..

Actions

This Discussion