Configuration circuit frame-relay

Answered Question
Mar 17th, 2008
User Badges:

Hi my friends,


I configured a circuit frame-relay but the connection with internet is not functioning normally. The command ping functions normallly for both the IP address WAN, but exist problem for access internet sites. My services provider indicate that at moment my circuit is up and that not is showing problem. Is necessary other configurations for router allow routing for the internet ?


Thanks,


Bruno Santos

Correct Answer by Rick Morris about 9 years 2 months ago

You have 2 of the best helping you out on this post.


Without knowing your setup it is impossible to know where to point you. If you do not feel comfortable posting your config, check your default route.


ip route 0.0.0.0 0.0.0.0


example:

ip route 0.0.0.0 0.0.0.0 serial0/0.500


This tells your router that any traffic looking for a route not in your routing table to go out the serial interface, your ISP and have them route the traffic across the internet to find the IP you are looking for.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
paolo bevilacqua Tue, 03/18/2008 - 02:04
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Send output of show interface and show frame-relay pvc xy.

Also can you describe what mean "problem for access" ?

Richard Burts Tue, 03/18/2008 - 05:49
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Bruno


I agree with Paolo that we need more information about your configuration and a better definition of what the problem is.


Based on what we know so far my first guess at the problem is that you are probably using private addressing on the inside of your network, public addressing on the frame relay link, and that address translation is not set up (or has some problem).


In addition to the things that Paolo is asking for I would ask that you post the config of the router.


HTH


Rick

Correct Answer
Rick Morris Tue, 03/18/2008 - 06:50
User Badges:
  • Silver, 250 points or more

You have 2 of the best helping you out on this post.


Without knowing your setup it is impossible to know where to point you. If you do not feel comfortable posting your config, check your default route.


ip route 0.0.0.0 0.0.0.0


example:

ip route 0.0.0.0 0.0.0.0 serial0/0.500


This tells your router that any traffic looking for a route not in your routing table to go out the serial interface, your ISP and have them route the traffic across the internet to find the IP you are looking for.

brunosantosnet Tue, 03/18/2008 - 09:55
User Badges:

My friend,


Really, I don't configured the default route, now my connection it is normal.


Thanks,


Bruno Santos

Rick Morris Tue, 03/18/2008 - 09:58
User Badges:
  • Silver, 250 points or more

I am sorry I don't understand.


You configured the default route and now it works?


or it just works now and you did nothing?


please make sure to rate posts that worked and helped so the netpro community who searches can find valuable posts with results.


Thanks,


Rick

brunosantosnet Wed, 03/19/2008 - 16:37
User Badges:

Rick,


Yes, I configured the default route and now it works normally.


Very good,


Thanks.

Actions

This Discussion