ASA multiple context and sla monitor

jackson.ku · ‎03-17-2008

Hi,

Can I use both multiple context and sla monitor in my ASAs? I can not use sla monitor if enable multiple context. Please help to identify the problem.

Thanks & Best Regards,

Jackson Ku

amritpatek · ‎03-21-2008

SLA monitor has no such restriction with relation to multiple contexts on ASA. Following links may help you

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00808d2b63.shtml

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/contexts.html

jackson.ku · ‎03-21-2008

Hi,

But it can not accept "sla monitor" command in my ASA with multiple security context?

Best Regards,

Jackson Ku

d-g-c · ‎02-11-2010

Hi,

I also have the same issue. We are running an ASA 5520 7.2(4) in multiple context mode. I cannot enter the "sla monitor" command, as it is not recognised.

The only reference I can find regarding SLA monitor setup, is concerning the ASA 8.0 code.

SLA Monitoring on ASA

Problem:

SLA monitoring does not work after the ASA is upgrade to version 8.0.

Solution:

The problem is possibly be due to the IP Reverse-Path command configured in the OUTSIDE interface. Remove the command in ASA and try to check the SLA Monitoring.

Apologies if I am missing something blindingly obvious, however does anyone know why the command's don't seem to be recognised on our setup (multiple context, 7.2(4)?

Thank you for your help,

Kris

Kureli Sankar · ‎02-11-2010

If you read this command reference link for sla monitor:

http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/s8.html#wp1506676

It is only supported in single routed mode. See the table.

Command Modes

The following table shows the modes in which you can enter the command:


Command Mode	Firewall Mode		Security Context
	Routed	Transparent	Single	Multiple
	Routed	Transparent	Single	Context	System
Global configuration	•	—	•	—	—

-KS

d-g-c · ‎02-11-2010

Hi kusankar,

Thanks for your help - much appreciated!

Kris