03-18-2008 03:26 AM - edited 03-05-2019 09:49 PM
Hi All
Can I still configure these connections between the stack swiches (2 x 3750) and the 2960s as etherchannels and trunk?
And if I can do etherchannel, is this set up regarded as cross stack thereby I have to set the etherchannel as "on"
Thanks
03-18-2008 05:52 AM
Hi,
Yes i think it can as the stack is been seen as 1 logical unit. If it is not stacked with a stackwise cable, i don't think it can as cisco doesn't support spilt channeling.
Regards
J.
03-18-2008 07:37 AM
If its cross stack you would use on or active as I believe it will support LACP for cross stack. Does not support PAGP for cross stack etherchannel.
03-19-2008 10:07 AM
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: