03-19-2008 09:21 AM - edited 03-15-2019 09:32 AM
Hi all,
does anyone knows what are the paremeters for configure a Pri line throught MGCP in a Callmanager?
(PRI Protocol Type, line codinf, framing, ...)
thanks in advance
Solved! Go to Solution.
03-19-2008 09:33 AM
Like all European contries, switchtype primary-net5, linecode hdb3, framing usually crc4.
hope this helps, please rate post if it does!
03-19-2008 09:33 AM
Like all European contries, switchtype primary-net5, linecode hdb3, framing usually crc4.
hope this helps, please rate post if it does!
03-19-2008 09:38 AM
that's correct, the problem was that I selected a T1 interface instead E1 one. therefore this parameters didnt appear. Now it's correct.
thank you very much for your faster answer.
03-19-2008 09:40 AM
You're welcome, please remember to rate posts using the scrollbox below!
03-19-2008 09:59 AM
thanks again,
Do you Know how can I receive all calls (from this Pri line) in a Line Group?
The MGCP gateway is configured.
The line group is Configured.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide