03-19-2008 09:21 AM - edited 03-15-2019 09:32 AM
Hi all,
does anyone knows what are the paremeters for configure a Pri line throught MGCP in a Callmanager?
(PRI Protocol Type, line codinf, framing, ...)
thanks in advance
Solved! Go to Solution.
03-19-2008 09:33 AM
Like all European contries, switchtype primary-net5, linecode hdb3, framing usually crc4.
hope this helps, please rate post if it does!
03-19-2008 09:33 AM
Like all European contries, switchtype primary-net5, linecode hdb3, framing usually crc4.
hope this helps, please rate post if it does!
03-19-2008 09:38 AM
that's correct, the problem was that I selected a T1 interface instead E1 one. therefore this parameters didnt appear. Now it's correct.
thank you very much for your faster answer.
03-19-2008 09:40 AM
You're welcome, please remember to rate posts using the scrollbox below!
03-19-2008 09:59 AM
thanks again,
Do you Know how can I receive all calls (from this Pri line) in a Line Group?
The MGCP gateway is configured.
The line group is Configured.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: