03-19-2008 12:46 PM - edited 03-05-2019 09:51 PM
Hello,
I have recently setup an MRTG system at work to monitor many, many devices. All is well with most all of the devices, however, the uBRs don't seem to wanna cooperate. All of the graphs for the cable interfaces have spikes in them. The spikes throw off the scale of the graphs quite a bit...to the point where they are nearly useless. Have any of you ever used a system like MRTG to monitor uBRs? If so, have you ever seen spikes in the graphs? If you did see spikes, what did you do to correct this?
--Thanks
03-19-2008 11:23 PM
Please put some screenshots. Those spikes are only in the day where you start mrtg or all the time ?
You can put something like this in mrtg.cfg to each interface
MaxBytes[ubr10k_2]: 12500000
03-20-2008 12:41 PM
Here is an example:
http://img502.imageshack.us/img502/887/172229117cable504dayhw9.png
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: