Problem in show ip route?

Unanswered Question

Is someone who can help me? What is the meaning of the result "%Network not in table"?

Router>show int serial1

Serial1 is up, line protocol is down

Hardware is MK5025

Description: ****Example****

Internet address is 192.168.1.1/30

MTU 1500 bytes, BW 512 Kbit, DLY 20000 usec, rely 131/255, load 1/255

Encapsulation PPP, loopback not set, keepalive set (10 sec)

LCP Listen

Closed: IPCP, CDPCP

Last input 00:07:58, output 00:00:14, output hang never

Last clearing of "show interface" counters 12:50:32

Input queue: 0/75/0 (size/max/drops); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/1000/64/0 (size/max total/threshold/drops)

Conversations 0/75/256 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

92 packets input, 7719 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

29464045 input errors, 29253742 CRC, 0 frame, 210307 overrun, 0 ignored, 0 abort

9611 packets output, 134554 bytes, 0 underruns

0 output errors, 0 collisions, 2415 interface resets

0 output buffer failures, 0 output buffers swapped out

2451 carrier transitions

Router>show ip route 192.168.1.1

% Network not in table

Router>

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

The Serial interface is not up/up, it sees a physical connection but no protocol.

The connected 192.168.1.1 address will only be in the routing table if interface and line protocol are both up.. This is a PPP encapsulated interface and it appears possible the other end of the PPP link isn't uup or configured properly.

Actions

This Discussion