cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
486
Views
0
Helpful
1
Replies

PXE boot through FWSM

kschuerman
Level 1
Level 1

I am attempting to setup a windows deployment server to work through our FWSM. The workstation and DHCP servers are on different vlans on the outside interface of the FWSM. The WDS is a separate vlan on a different FWSM interface. The workstation is getting an IP and I verified that it is receiving option 66 and 67 using wireshark.

The client will get an IP address at boot, but I receive a TFTP open timeout error. I do not see any deny messages in the FWSM log viewer. I do have an ACL allowing TFTP to the WDS from any.

Does the WDS server need to be listed as a DHCP relay server in the FWSM config?

Any other possible solutions?

Thanks.

1 Reply 1

kschuerman
Level 1
Level 1

I just realized this went into the wrong category, is there anyway to move it?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: