Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1050
Views
0
Helpful
1
Replies

PXE boot through FWSM

kschuerman
Level 1
Level 1

‎03-21-2008 09:38 AM - edited ‎03-11-2019 05:20 AM

I am attempting to setup a windows deployment server to work through our FWSM. The workstation and DHCP servers are on different vlans on the outside interface of the FWSM. The WDS is a separate vlan on a different FWSM interface. The workstation is getting an IP and I verified that it is receiving option 66 and 67 using wireshark.

The client will get an IP address at boot, but I receive a TFTP open timeout error. I do not see any deny messages in the FWSM log viewer. I do have an ACL allowing TFTP to the WDS from any.

Does the WDS server need to be listed as a DHCP relay server in the FWSM config?

Any other possible solutions?

Thanks.

Labels:
0 Helpful
1 Reply 1

tstanik
Level 5
Level 5

‎03-27-2008 12:16 PM

You need to enable dhcp relay on FWSM. In order to enable DHCP relay on the interface connected to the clients, enter these commands:

dhcprelay enable Outside

dhcprelay server ip_address Outside

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card