I am running CCM 4.2. I have a facility that uses a 2820 (h323) for outbound cals through a T1. When calls are placed, the router sees the call but it takes 10 seconds before the call rings out. During this time the IP phone says "call proceed. This setup was working fine, we relocated the office to a new location, the equipment changed but as far as I can tell the configs were matched 100%. I am out of ideas, ay help is greatly appreciated.
If nothing changes, collect "debug vpm signal" with "term mon". Please configure "service timestamps debug msec" beforing doing so.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
