MPLS PE/CE configuration

Unanswered Question
Mar 22nd, 2008
User Badges:

I am tasked to make a local connectivity within one site. The interface vlan was associated to specific VRF. This Interface Vlan is being implemented with HSRP. From the router, i only got successful ping to HSRP gateway. Ping to host elements are not possible. Let me know your views also.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Edison Ortiz Sun, 03/23/2008 - 09:35
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

When pinging any of those addresses, you need to include the vrf option in the ping command.


Can you post your config?


Here is my config and it works:



ip vrf NETPRO

rd 1:100


interface FastEthernet0/0

ip vrf forwarding NETPRO

ip address 192.168.1.1 255.255.255.0

duplex auto

speed auto

standby ip 192.168.1.254




Rack1R1#sh ip route vrf NETPRO


Routing Table: NETPRO

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

E1 - OSPF external type 1, E2 - OSPF external type 2

i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

ia - IS-IS inter area, * - candidate default, U - per-user static route

o - ODR, P - periodic downloaded static route


Gateway of last resort is not set


C 192.168.1.0/24 is directly connected, FastEthernet0/0

Rack1R1#ping vrf NETPRO 192.168.1.1


Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms

Rack1R1#ping vrf NETPRO 192.168.1.254


Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.1.254, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 4/5/8 ms

Rack1R1#


HTH,


__


Edison.


Actions

This Discussion